SMOOTH mode is a Er:YAG treatment modality that delivers laser energy onto the skin in a fast sequence of low-fluence laser pulses inside an overall super-long pulse of 200-350 msec. Because SMOOTH pulses are longer than the epidermal TRT, the effect of SMOOTH mode is gentle coagulative heating of the skin without any significant ablation of
Find out if Erbium laser treatments are what you need to look the way you desire. Call the friendly staff at The Naderi Center in Chevy Chase, Maryland, 301-222-2020 or Reston, Virginia, 703-481-0002 to schedule a consultation. The Sciton® erbium laser is considered: The finest resurfacing laser available which provides patients with the best results with the least risk of complications. The procedure is performed by our physicians in their nationally certified surgery center, which shares a building with the Medical Spa. Local anesthesia with mild sedation is all To understand how the laser light cuts the soft tissue, clinicians should examine how its absorption coefficient spectrum [1-5] applies to the three wavelength groups of practical dental lasers presented in Figure 1: circa 1,000 nm (diodes and Nd:YAG laser); circa 3,000 nm (erbium lasers); and circa 10,000 nm (CO 2 lasers). The near-IR diodeNd:YAG Diode Lasers Erbium glass lasers Alexandrite lasers 500-1299 nm 585-595 nm 589-598 nm 532 nm 1032 & 1064 nm 1450 nm 1540 nm Tighten the skin by collagen synthesis stimulating by the wound healing process. Less destructive than ablative lasers. Heat dermis. Fractional lasers Ablative Non-ablative Er:YAG Co 2 Erbium glass 2940 nm 10600 nm
Following irradiation, mice were shaved using a motorized electric clipper and carefully inspected to be sure that only hair was shaved without injury to the underlying skin. Once mice were shaved, they were treated with a Sciton Er/YAG fractional laser. Laser parameters varied from 35 to 500 mj at 11–22% density with no coagulation. The Erbium YAG Laser works by producing energy in the mid infrared invisible light spectrum, which is 10-15 times more efficiently absorbed by water in the skin compared to the energy emitted by CO2 lasers. The laser energy instantly vaporizes skin and tissue in a very precise manner, while leaving surrounding skin unharmed and hardly affected.This type of erbium laser can be found at wavelengths of 1540 or 1550 nm, which are classified as non-ablative erbium glass, and at 2940 nm, classified as ablative erbium YAG.
What is the average cost of a non-ablative fractional laser skin resurfacing procedure? A non-ablative fractional laser skin resurfacing procedure can cost anywhere from $1,000 to $1,200. The actual cost of a non-ablative fractional laser skin resurfacing is dependent upon location, provider, and length and involvement of the cosmetic procedure. .